Joining wall components of dissimilar walls?

[techdef]

Folks, having a wall component join issue. Walls dont meet at 90 degrees and are not the same height. They're roof parapets. Also different colors of stucco. I havent been able to get the wall join, nor component join tools to work well in this situation as you cant cap the higher wall successfully.

 

Alternately, some way to use the end-cap tool but choose an angle?

 

Any thoughts?

Edited January 11, 2022 by techdef

[zoomer]

T-joint and manual Component joint afterwards ?

[techdef]

That's exactly what I was trying. It fails with walls of different heights, leaves the upper portion uncapped.

 

I ended up duplicating the taller of the parapet walls and making one the same height as the lower, and one just the upper portion. Was able to join the lower 2 walls in an L and then cap the upper. Its pretty close.

[zoomer]

It has been some time but I had similar and was able to get what I want with

T-Join and a bit of Component Join at that time ...

(Not that many components though)

 

Maybe you can post the Walls in a File to make us try.