Mike Wright Posted September 20, 2021 Share Posted September 20, 2021 I'm trying to correctly configure this box corner. I have all faces behaving as should apart from the face which is coincident with the insertion point. It will not offer this as a connection point. Pictures below show the maximum number of faces I can occupy plus the corner block settings (VW 2021 SP4.1) Quote Link to comment
Vectorworks, Inc Employee JustinVH Posted September 20, 2021 Vectorworks, Inc Employee Share Posted September 20, 2021 @Mike WrightAre you able to share the file so I can have a look? You can message it to me is needed. Quote Link to comment
Mike Wright Posted September 20, 2021 Author Share Posted September 20, 2021 Hi Justin Thanks for the quick response, file attached I'm also having problems using the same corner in braceworks if you are able to assist with that. H40V box corner try out.vwx Quote Link to comment
Vectorworks, Inc Employee JustinVH Posted September 20, 2021 Vectorworks, Inc Employee Share Posted September 20, 2021 I took a look at the file and the issue is that the cross section values are showing the truss length and width dimensions of 0mm (screenshot with blue oval). If the dimensions have no values the auto connect will fail and that is why things were not connecting to the left. I was able to fix this by going into the Truss Properties and reassigning the H40V cross section to the piece of truss and clicking 'ok' in the dialog. The trick is to make sure that the length and width are 387mm (screenshot with green oval). By reassigning the cross section the length and with will auto populate because the dimensions are defined by the cross section. Once I corrected the missing dimensions the truss corner behaved like expected. Quote Link to comment
Mike Wright Posted September 21, 2021 Author Share Posted September 21, 2021 Awesome! Thanks for your help. It would appear that that value is zero for all Prolyte truss in the library, I guess this doesn't matter on trusses with a value for length but will for corners like this. Quote Link to comment
Vectorworks, Inc Employee JustinVH Posted September 21, 2021 Vectorworks, Inc Employee Share Posted September 21, 2021 Thanks for pointing this out. That is an issue that I will be fixed. All truss should have a cross section assigned so that Braceworks will function properly. If the data is not available then it should be set to Rigid. Regardless, all truss should have values in length and width. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.