Is it possible to have different line weights in the snap to grid, lines?
I see you can have a snap grid and reference grid - Is there any way these can be made visible at the same time?
When creating ConnectCAD schematics for example. I have a 4x4 unit snap grid but I like to space may components out on say a 8 unit grid. The 16x616 grid just needs to be shown in a slightly heavier line weight. In AutoCAD I think they refer to this as a 'major' grid line.
@Conrad Preenbeing able to 'force' snapping of ConnectCAD devices to the major grid would be a handy feature to speed the laying out of devices uniformly (horizontally primarily, not so sure about vertical though!
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Ross McLee
Hi!
Is it possible to have different line weights in the snap to grid, lines?
I see you can have a snap grid and reference grid - Is there any way these can be made visible at the same time?
When creating ConnectCAD schematics for example. I have a 4x4 unit snap grid but I like to space may components out on say a 8 unit grid. The 16x616 grid just needs to be shown in a slightly heavier line weight. In AutoCAD I think they refer to this as a 'major' grid line.
@Conrad Preenbeing able to 'force' snapping of ConnectCAD devices to the major grid would be a handy feature to speed the laying out of devices uniformly (horizontally primarily, not so sure about vertical though!
Thanks,
R
Link to comment
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.