Ross McLee Posted August 9, 2021 Share Posted August 9, 2021 Perhaps a bit of fun, here.  But I did a connector check on my last drawing. and got the attached!  Glad I only did one check at a time (this took my laptop about 20 minutes to compile. Unfortunately, I can't do anything with the information it is just too dense! 🙂  LOL R Quote Link to comment
Vectorworks, Inc Employee Nikolay Zhelyazkov Posted August 10, 2021 Vectorworks, Inc Employee Share Posted August 10, 2021 Hello @Ross McLee, Â Check drawing command is very strict in its rules. I would suggest that you execute it earlier in your workflow so that you can get any errors earlier and fix them and avoid such big drawings full of errors. Additionally, you can check for a single category of errors only, in order to get less error markup. Â Best Regards, Nikolay Zhelyazkov Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.