David Dauphin Posted July 26, 2021 Share Posted July 26, 2021 (edited) Hello, I just begin to convert my Lighting devices v2020 in v2022 (with 2022 beta SP04). So I delete clamps from my old lighting devices, then I created clamps as "lighting accessory" that could be use with my new "lighting devices" library, and now I would like to create tripod and base as "lighting accessory" too. So I create tripod and baseplate like clamps, that means symbols in 3D must be under z0 and upside-down. Is it the right way to do that, or is there a special way for those plate/tripod that I doesn't see in VWX2021 / 2022 ? Here are screenshot of 2 lighting devices both with clamps and tripod/baseplate, and screenshot of my 3D tripod symbol/ Edited July 26, 2021 by David Dauphin Quote Link to comment
markdd Posted July 26, 2021 Share Posted July 26, 2021 I tend to think of tripods and baseplates etc as Hanging Positions so do not attach them as accessories. The Accessory geometry that you pre-load into a Lighting Device should be placed above the ground plane (Z is >0) with the Lighting Device geometry below it. 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.