Viper x Posted May 26, 2005 Share Posted May 26, 2005 I had a vw10 drawing that I converted to 11, all looked fine and the plants were intact. I have then copied hundreds the plants in the vw11 drawing and pasted them into another vw 11 drawing but only the tags and the small x in the middle of the symbol shows up. I know the plant symbol is made up of 2 parts and I have made sure both the none class and the class the plants are in are turned on in both drawings. What have I done wrong please ? I can copy and paste all the plants in the same drawing OK but when I try to paste them in the new VW11 drawing no symbols appear. I have no symbols even when I copy and paste into a new blank vw11 drawing [ 05-26-2005, 04:23 AM: Message edited by: Viper x ] Quote Link to comment
Vectorworks, Inc Employee Robert Anderson Posted May 26, 2005 Vectorworks, Inc Employee Share Posted May 26, 2005 1. Check your class visibility options. It should not be "active only". 2. Do the symbols have internal classing? Make sure all the internal classes (if any) are turned on. 3. What is the fill and line style assigned to the plants? Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.