LCarm Posted July 12, 2021 Share Posted July 12, 2021 Hello all, I am having a hard time using the site modifiers tool in Vectorworks Architect. My intent is to place a vertical edge using the Pad with retaining edge mode, but it doesn't give me the option to establish a vertical edge. Is there a setting for this tool that creates a vertical edge instead of a sloped "terrain" edge. I have attached an image with the settings I am using. Thank you very much.@Wes Gardner @Pat Stanford Quote Link to comment
Pat Stanford Posted July 12, 2021 Share Posted July 12, 2021 VW does not allow vertical edges. Give is a very slight angle (1 mm, 1/16") and you should be OK. 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.