Adobe mucked up my computer the other day. There were some issues with the C++ runtime. After rolling back to a previous restore point everything was working again. Vectorworks seemed fine yesterday except fit to walls wasn't working properly. Again this morning, the fit walls to objects wasn't working properly. This afternoon, changes in the OIP for walls stopped working. I could only change wall height by going into components and adjusting the height there. So reinstalled VW but the problem persists. VW as part of its install reinstalled the C++ runtime so that shouldn't be the problem. Not sure where to go from here. Any suggestions out there?
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
KrisM
Adobe mucked up my computer the other day. There were some issues with the C++ runtime. After rolling back to a previous restore point everything was working again. Vectorworks seemed fine yesterday except fit to walls wasn't working properly. Again this morning, the fit walls to objects wasn't working properly. This afternoon, changes in the OIP for walls stopped working. I could only change wall height by going into components and adjusting the height there. So reinstalled VW but the problem persists. VW as part of its install reinstalled the C++ runtime so that shouldn't be the problem. Not sure where to go from here. Any suggestions out there?
Link to comment
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.