ConnectCAD Arrow connector label

[Ross McLee]

Hi again,

Finding my way around ConnectCAD a little more comfortably.

Q: When connecting two sockets using the arrow connector type OR when connecting two sockets across two layers. Is it possible to customise what the circuit label displays?

 

It would be particularly handy for example if the label said the destination room or rack. When a circuit crosses between two layers, displaying the layer names is not particularly helpful (especially if they are simply called schematic 1 and schematic 2). I suppose I could change the devices to be more descriptive of the location, but would prefer to automate it through the location: room or even rack properties. 

 

Example of all the variants I have come across so far, attached. Note: Show all layers is on, so you can see all three layers clearly.

 

Thanks as always,

R