MGilc Posted January 6, 2021 Share Posted January 6, 2021 I've a question about the method of creating slabs, as I think I'm doing it wrong. When I create my walls, I use the slab tool which creates the slab and always it sits below the walls (see picture from tutorial from Vectorworks university Essentials). But this isn't how a slab and external wall would be. The walls would go right down to the External ground level, not float above it with an exposed slab; Currently my model has this exposed slab around it (see picture) as the tutorial does it. The walls are on 0 elevation, and the walls built up from the top of the slab, the slab built from top down. I saw a different variation from Jonathon Reeves with the base brick (see picture) How would this be done? Does he essentially draw another base wall around the slab? Quote Link to comment
MGilc Posted January 6, 2021 Author Share Posted January 6, 2021 For slabs, should the external walls not start from elevation 0, the slab sit on top of that (so it's surrounded by the external walls) and then all your internal walls will have to have a different elevation (therefore a different layer?) so they all sit on the slab ??? Very confused. What is the correct way to have slabs?? Surely not how the tutorial Essentials suggests. Quote Link to comment
MGilc Posted January 6, 2021 Author Share Posted January 6, 2021 from university tutorial Essentials Quote Link to comment
Tom W. Posted January 6, 2021 Share Posted January 6, 2021 Very briefly: set the bottom of your walls to 0 + the top of your slab to 0 but then give the outer component/s of the wall a negative offset to lower them to the correct elevation so that they cover the edge of the slab. You basically want the structural component of the wall sitting on top of the slab + the cladding components running long. Set the slab so it's bounded to the outside of the wall core or wherever exactly you want it depending on the construction detail. I'd imagine Jonathan Reeves used two walls like you say: a plinth wall that the slab is bound to plus the walls proper sat on top. But equally it may be a single wall with the top (render) component given a positive offset so it doesn't extend right down to the bottom 2 Quote Link to comment
MGilc Posted January 6, 2021 Author Share Posted January 6, 2021 Ahh I get it thank you! Quote Link to comment
E|FA Posted January 6, 2021 Share Posted January 6, 2021 (edited) Also look at the settings of your Wall Component Settings and Slab Edge Offsets. https://app-help.vectorworks.net/2021/eng/index.htm#t=VW2021_Guide%2FFloors_slabs%2FSetting_edge_offsets.htm https://app-help.vectorworks.net/2021/eng/index.htm#t=VW2021_Guide%2FWalls%2FCreating_wall_components.htm Edited January 6, 2021 by E|FA Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.