Jump to content

Stamped pan in 3d


Recommended Posts

its part of a ss fabrication for a shop. They are going to modify it and use it for a cover for some electronics...so I need to make shop drawings showing the location of holes and such and that it has enough clearance etc....so I modeled it in VW but exported it to Onshape...

 

VW has a better way of tracing over an imported image than Onshape...since tracing is 2d with an image below..

  • Like 2
Link to comment

I guess that is the down side of 3d...once you start then everything in the model need to be shown so BOMs can be made etc...one could have just made a graph paper sketch  but then you have this single paper sketch that is outside the 3d model universe then it gets forgotten...

Edited by digitalcarbon
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...