"Unafilliated" Walls Slabs Ceilings, etc.

[salukitd]

I very much appreciate everyone's kind comments on my last question.  The truth is, is that I am trying to re draw my house based off of a crappy, scanned six times plan and some measurements so I can do some work down the road.  I would just like to draw a slab and walls (with styles) and not have them affiliated with a particular floor, layer height/elevation.  I'd just be happy with drawing the pieces then moving them into whichever place they need to be!  I'm a theatrical scenic designer by trade and very rarely, if ever need to deal with these things.

 

Thanks again,

 

Pat

[E|FA]

It might have been lost in all of the other comments on the other thread, but you can ignore the Story/Level system if you set up the model appropriately.  Here's what you'll need to get started:

 

 

[Pat Stanford]

All walls have to have some "affiliation" They can either be Story Bounded or Fixed Height.

 

Fixed Height Walls insert at the level of the Layer they are on.

 

If you don't care a lot about the specifics, use Fixed Height walls and convert them to Unstyled so you can move them as you see fit.