Mark Aceto 431 Posted October 1, 2020 (edited) I'm looking for a way to hide hoist chain and hooks when used as a Drop. In the screenshot below, you can see that the Tyler GT Lift Plates, STAC and shackles are all attached properly (altogether as a truss pickup assembly). The entire system is BW-aware, so I just need to hide the chain and hooks visibility. Where I'm stuck is that I can only successfully hide the top hook with classing. I'm not sure how to get to the chain (or simple chain which is an extrude) or the bottom hook from within the hoist PIO. I obviously don't want to hide every hook and chain in the entire drawing (just the torms). Edited October 1, 2020 by Mark Aceto Quote Share this post Link to post