I am working on some Bleachers and I ran into a problem. The only snappoint that would work is in my symbol at Z=20cm as you can see in the picture. So, if I put this bleacher in the venue it will be 20cm below Z= 0, even though it says Z=0.
Is it possible to use this snappoint and tell Vectorworks to put it higher relative to the Z value?
I realize my explanation is a bit vague but I don't know how to properly explain it otherwise.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
ztijnf
Hi,
I am working on some Bleachers and I ran into a problem. The only snappoint that would work is in my symbol at Z=20cm as you can see in the picture. So, if I put this bleacher in the venue it will be 20cm below Z= 0, even though it says Z=0.
Is it possible to use this snappoint and tell Vectorworks to put it higher relative to the Z value?
I realize my explanation is a bit vague but I don't know how to properly explain it otherwise.
Link to comment
6 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.