LCarm 5 Posted September 4, 2020 I have large openings in a CMU wall that show up as solid, how do I make them dashed line type? I made the openings with a bottom offset from top of slab. Thanks VeeDub Forum Quote Share this post Link to post
Wes Gardner 334 Posted September 9, 2020 @LCarm like this? dashed in plan.vwx Quote Share this post Link to post
Mitchell (the other one) 17 Posted September 9, 2020 Well, there is a "duh" moment for me. I'm stealing borrowing that technique. And adding another beer to the total that I owe Wes. Quote Share this post Link to post
LCarm 5 Posted September 9, 2020 Thank you! I also stumbled upon the "Enable Cut Plane at Layer Elevation" which also worked for my situation where the openings go to the floor... but I will definitely use this technique, also a "duh" but I have a lot of those in my newbie-ness. Quote Share this post Link to post