LCarm Posted September 4, 2020 Share Posted September 4, 2020 I have large openings in a CMU wall that show up as solid, how do I make them dashed line type? I made the openings with a bottom offset from top of slab. Thanks VeeDub Forum Quote Link to comment
Guest Wes Gardner Posted September 9, 2020 Share Posted September 9, 2020 @LCarm like this? dashed in plan.vwx Quote Link to comment
Mitchell (the other one) Posted September 9, 2020 Share Posted September 9, 2020 Well, there is a "duh" moment for me. I'm stealing borrowing that technique. And adding another beer to the total that I owe Wes. Quote Link to comment
LCarm Posted September 9, 2020 Author Share Posted September 9, 2020 Thank you! I also stumbled upon the "Enable Cut Plane at Layer Elevation" which also worked for my situation where the openings go to the floor... but I will definitely use this technique, also a "duh" but I have a lot of those in my newbie-ness. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.