Jump to content

Electrical Circuits

Recommended Posts

 I just started playing with Electrical Circuits for a small project and decided to extend it out to my building.

My issue is that the building has quite a bit of 3 phase  and 220 electrical.


One of my main panels is 3 phase 400amp with disconnect.

I didn't see anything like that in supplied panels so a custom one is needed? How do I do that?

How do I set it up so my home runs show the 2 or 3 breakers that control one location?


Also most of these end at a Fused disconnect. Is there a way to notate these?



Share this post

Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114


© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

  • Create New...