marek.dk Posted January 10, 2006 Share Posted January 10, 2006 hello, i organized my drawing with the model setup and I gave z heights FF to the different mod-floor layers. problem: when I look at the model in front view or isometric view, all walls in all layers seem be in the same z level. and not on top of each other as supposed and organized in the model setup. what could it be? thanks marek Quote Link to comment
islandmon Posted January 10, 2006 Share Posted January 10, 2006 Use Design-Layer > 'delta Z' or unlock the Mod-Layer > Layer Links and manually repostion the Floor Plan Layers to the coorect Z values. Quote Link to comment
marek.dk Posted January 10, 2006 Author Share Posted January 10, 2006 I couldn?t figure out how I could go the ways you recommended. But when I created a section view and used the stack layers command the layers suddenly were positioned as supposed on top of each other in their z-values. so I hope it will work from now on. Quote Link to comment
Jonathan Pickup Posted January 10, 2006 Share Posted January 10, 2006 Marek, when you want to look at the 3D view, either use the stacked layers command or create a new layer ( i call it Mod-3D Model) and layer link all the other model layers (floors) into it. Then you should see all the other floors stacked up neatly. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.