Giovanni Posted June 5, 2020 Share Posted June 5, 2020 I've done a roof as visible on Fig01.png There's a problem with the joint of the two roof faces (See Fig02.png) We have try to use roof joint tool but it works only on one of the two faces (See Fig03.png and Fig04.png). Quote Link to comment
Giovanni Posted June 5, 2020 Author Share Posted June 5, 2020 Here attached you can find the original file. Thanks! Stato Progetto Copertura.vwx Quote Link to comment
P Retondo Posted June 7, 2020 Share Posted June 7, 2020 Try joining the two roofs, using this tool in the modes shown: Quote Link to comment
Giovanni Posted June 7, 2020 Author Share Posted June 7, 2020 @P Retondo Thank you Pete, I've used that tool, but i works only on the left side. You can see this on the 4th picture. Quote Link to comment
P Retondo Posted June 8, 2020 Share Posted June 8, 2020 Try this: edit the roof planes (select and < cmd+[ >), and drag the peaks of the each polygon beyond the junction. Then join, making sure you are using the second mode as shown in the screen grab above (Dual Object Connect Mode). If that does not work, just create a new roof from a rectangle, you should be fine. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.