jsivonen Posted June 2, 2020 Share Posted June 2, 2020 Hi, Is it possible to change the default handle size of the Connect tool? In this picture I have the J1-J2 Power link drawn in strahight vertical line, how I want it and can be adjusted with the Reshape tool. The K1-K2 Power is how the Connect tool draws it by default. I need to make 400 of these lines so adjusting them all with the Reshape is not an option. I could just use the line tool and Duplicate, but that would miss the point of the Connect tool? Thanks, Janne Quote Link to comment
Daniel Dickman Posted June 2, 2020 Share Posted June 2, 2020 Could you just duplicate the circuit line from J1-J2 to K1-K2? Since its already its already formatted the way you want, you should just be able to duplicate it and drag onto the K1-K2 circuit. 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.