Jump to content

need advice on import dwg

Recommended Posts

Work with people who have a better understanding of what is needed in a drawing? ;-)

It sounds like whoever prepared the venue drawing just took the drawings from the seat manufacturer and dropped them in. Since all of that data exists in the DWG, there is not a lot you can do other than ask whoever gave it to you to clean it up on their end or clean it up on your end.


Perhaps you can bring it into a "shuttle file" drawing and then use a Design Layer Viewport to bring into you working file. That may allow you to turn off classes that you don't need and lighten the file enough to be workable.


Good Luck.

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...