Jump to content
Mr_Brooks

Looking for proportional command

Recommended Posts

Hi all,

 

Let's say we have 3 differents walls with different heights.

I'd like to increase proportionaly its heights on Object Info cell "Height"

Is there a command to do that?

Something similar than C4D "num +100"

 

Thanks

 

Share this post


Link to post

Hi

You can change the height by adding + 100 after the current height in the OIP, but if you choose several with different height they will all get the same height.

Share this post


Link to post

Thank you for reply,

 

I'm looking for proportional behavior (something like "x +100" should add 100 units to each wall height even if walls have different heights)

 

 

 

Share this post


Link to post

I don't think it's possible. It's only working for walls with the same height. 

Share this post


Link to post

If the bottom offsets are the same then you move them all vertical vertically 100 then readjust the bottom offsets back to what they were. You would have to readjust any doors or windows or symbols in the wells back down 100 tho.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...