I have a few custom Dimension lines, & two relate to Structural Call-outs. If I have a Joist call out showing the bearing but on the other end it's an outlook or cantilevered I have to put a white blob to cover the arrow. (Bad Drafting always results in bad buildings!)
I would love to have the ability to change the "Arrowheads" at both ends of a custom Dimension so I could have no arrow at one end.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Jim Smith
I have a few custom Dimension lines, & two relate to Structural Call-outs. If I have a Joist call out showing the bearing but on the other end it's an outlook or cantilevered I have to put a white blob to cover the arrow. (Bad Drafting always results in bad buildings!)
I would love to have the ability to change the "Arrowheads" at both ends of a custom Dimension so I could have no arrow at one end.
Link to comment
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.