Jump to content
  • 0
SES_17

Projection Cones not lining up

Question

I've imported some new projector symbols into the "Projector Models" plug-in folder and edited the "Video Screen" tool so they can be added via the drop down menu in the OIP.  I can get these new projectors to add and display ok with the exception that each one shows the projection cone off by a different amount (pic attached).  Some of these new projectors were imported from the Service Select folders and others were symbols that I created with records attached.  All of the default, pre-loaded projectors display properly.  How do I change the projection cone location on these imported symbols?

VW-PJ.jpg

Share this post


Link to post

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...