Keito64 Posted April 20, 2020 Share Posted April 20, 2020 (edited) Hi all, I'm having some issues with the Component Join Tool. I've joined two walls (in the normal fashion - Wall Join Tool > L Join Mode > Uncapped Join Mode) and I would like to have the outer component of one wall finish on the back of the outer component of the other wall. However, whenever I try to do this (Component Join Tool > Capped Join Mode) the second selected wall pulls back to thickness of the first (screenshot below). The walls are the same height, thickness, at 90 degrees to each other; the only difference is the outer component. Any ideas what I'm doing wrong? (Vectorworks 2019 SP6) Original before component joining with desired effect in green mark up lines: Outcome: Edited April 20, 2020 by Keito64 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.