Jump to content
James Chipman

Object Duplication?

Recommended Posts

Hello all,

 

Does anyone know how to expand the number of blocks on a din rail terminal?

 

I have to draw a 150 port din rail, and the only way I have found is to draw 3 48 block units then go into each separate block and change the name.

 

TB.02.1-48 creates fine, but I can't create anything bigger.  I can create TB.02.1-48 again under that, but then have to go into each block and re-label it. conductor

 

Also, anyone have a suggestion on documenting a 3 conductor wire into a DIN terminal?  I would like to show all three wires on the block.  As well, any good ideas on how to make an internal jumper on the output side of a block?  ie. jump TB.02.27 to TB.02.29 on the output side?

 

Thanks for any assistance

 

Chippy

 

 

Share this post


Link to post

Hi James

 

At the moment the number of blocks is not adjustable, but I will make sure we take care of that ASAP. and let you know. Thanks for reaching out. Thank you also for showing me the detail workflow you need for these DIN blocks. This has been added to my plans and I will create a solution for this.

 

Conrad

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...