The following has been a source of personal irritation for many years...
- Use the detail tool set to place say a wide flange shape. As expected the size is readily found by scrolling the list presented when placing the shape in the drawing.
- Make your selection and the shape is placed in the drawing.
- Now, say you then want to either change the shape size using the OIP.
- The displayed list in the OIP defaults to the top of a very long list, NOT the size of the selected shape.
When working with many different shapes on a given project they tend to be within a fairly narrow range of sizes yet you are repeatedly forced to navigate the long list with each change.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
RGyori
The following has been a source of personal irritation for many years...
- Use the detail tool set to place say a wide flange shape. As expected the size is readily found by scrolling the list presented when placing the shape in the drawing.
- Make your selection and the shape is placed in the drawing.
- Now, say you then want to either change the shape size using the OIP.
- The displayed list in the OIP defaults to the top of a very long list, NOT the size of the selected shape.
When working with many different shapes on a given project they tend to be within a fairly narrow range of sizes yet you are repeatedly forced to navigate the long list with each change.
Link to comment
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.