Jump to content

load that is not attached does not issue an error message


Leppi

Recommended Posts

Hi,

yesterday we recognised a big problem within Vectorworks. We're using the German Version with SP2.1.1 R1 (build 523565).

We had a pipe attached on a truss witth cantilever to both side. There were single point loads on the pipe about 20cm away from the truss and we get the message that the load can not be attached to two strucural elements.

I did a test with Symbols from the library, so not using ours.

grafik.thumb.png.52dece8a71281fbee738941c2a0a3bfa.png

 

As you can see the single point load is not at the truss, and I don't get a warning that the load is not attached. It is also included in the calculation.

When i change the Trim hight of the system, loads height also will change.

 

Anyone else got this problem?

 

Best regards from Berlin, Germany


Sebastian

Edited by Leppi
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...