Pvz11 Posted February 12, 2020 Share Posted February 12, 2020 Hello, Just hoping someone can take a look at this, I am trying to make a bulkhead that is controlled by a path with the corners set to a sharp corner not rounded. See attached file. Thank you all for your time. Bulkhead control.vwx Quote Link to comment
m.graf Posted February 12, 2020 Share Posted February 12, 2020 (edited) Damned, only one Picture should upload.. "uncheck the smooth Corner option" Edited February 12, 2020 by m.graf Quote Link to comment
Pvz11 Posted February 12, 2020 Author Share Posted February 12, 2020 Haha...Thank you, much appreciated. Quote Link to comment
Vectorworks, Inc Employee SBarrettWalker Posted February 12, 2020 Vectorworks, Inc Employee Share Posted February 12, 2020 also, you should remove the Get 2D Vertex node and instead connect the Series node directly to the iIndex input of the Change Vertex Type node - its looking for integers, not points. Quote Link to comment
Vectorworks, Inc Employee SBarrettWalker Posted February 12, 2020 Vectorworks, Inc Employee Share Posted February 12, 2020 Actually, if you uncheck smooth corners, you don't need the Change Vertex Type node at all, so you can remove that whole section. Quote Link to comment
Pvz11 Posted February 12, 2020 Author Share Posted February 12, 2020 Hi, Thank you for the feedback, I did exactly that. I removed the change vertex/ get vertex and unchecked smooth and it works nicely. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.