barnes2000 Posted February 2, 2020 Share Posted February 2, 2020 When I use the Radius Selection Mode of the sculpting tool to push and pull the site model surface, is there a way to anchor the 2D boundary so that the boundary edge stays at zero? Quote Link to comment
Vectorworks, Inc Employee bgoff Posted February 2, 2020 Vectorworks, Inc Employee Share Posted February 2, 2020 Use and set the fall off value the higher the percent will give you your desired affects. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.