Jump to content

Isolating and Deleting Point Cloud with Clip Cube

Recommended Posts

It says in the manual: "Points isolation operations do not work on any points located outside of an active clip cube. However, I have repeatedly tried to isolate points with the assistance of a clip cube and when I delete them and then turn off the clip cube, it has taken a slice out of the entire point cloud. I have tried this a couple times over the years with a few different point clouds and given up each time. Am I missing something or is this a bug?

VW Help Snip.JPG

Edited by benelmo

Share this post

Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114


© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

  • Create New...