MaltbyDesign Posted October 24, 2019 Share Posted October 24, 2019 I found this post from early 2015 and was wondering if any solution has been found? Had hoped to be able to create a roof assembly using a slab and then rotate it to give it a 2% slope for a low slope roof. Since the create roof tool won't allow such a shallow roof, I was hoping I could do it with a slab, but apparently not. It may be that the only solution is to model the roof by its individual components. Quote Link to comment
Guest Wes Gardner Posted October 24, 2019 Share Posted October 24, 2019 @MaltbyDesign, yes, you can now! You need to use the Slab Drainage tool. I'll dig up some instructions and post them. Wes Quote Link to comment
Guest Wes Gardner Posted October 24, 2019 Share Posted October 24, 2019 @MaltbyDesign, here's a file with instructions built in...I have some other examples with "flat roofs" that require a slightly different slab style, it'll take me a bit to find them... Sloped Slabs.vwx Quote Link to comment
Guest Wes Gardner Posted October 24, 2019 Share Posted October 24, 2019 @MaltbyDesign. Here are some more instructions written a couple of years ago but I think everything still works...the icons may look different after they "reengineered" them this year.... Wes Slab Drainage Inst.zip Quote Link to comment
MaltbyDesign Posted October 24, 2019 Author Share Posted October 24, 2019 @Wes Gardner Thanks so much! It never occurred to me to use the drainage tool for this. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.