A McDonell Posted September 18, 2019 Share Posted September 18, 2019 Is there a way to get Space Labels auto centre when their geometry is edited? 1 Quote Link to comment
dc1 Posted February 18, 2020 Share Posted February 18, 2020 I second this question. Anyone know? Quote Link to comment
MarcelP102 Posted September 3, 2021 Share Posted September 3, 2021 3th, any possibility to center the label? Quote Link to comment
Boh Posted September 3, 2021 Share Posted September 3, 2021 I don’t think so. It would be a nice feature if there was a “centre label to space boundary” button. 3 Quote Link to comment
_James Posted September 6, 2021 Share Posted September 6, 2021 On 9/3/2021 at 9:07 PM, Boh said: It would be a nice feature if there was a “centre label to space boundary” button. A million times yes. It would also be nice if window and door tags could have a similar button. Quote Link to comment
Boh Posted September 6, 2021 Share Posted September 6, 2021 4 hours ago, _James said: It would also be nice if window and door tags could have a similar button. I don’t use the native door and window tools but the WinDoor tool from OzCad, which I understand will be included in vw2022 designer series general release, has a seperate tool for controlling the location, offset, number and incrementing of the WinDoor ID label. 1 Quote Link to comment
_James Posted September 13, 2021 Share Posted September 13, 2021 VW can control this, but it's too specific for 90% of the time. What I always almost do is half of the doors height and width to get a centre label. Then inevitably there are changes and they are off centre again. Looking forward to (the mythical) WinDoor in 2022! Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.