I just did a quick little test for schematic views.
I created a hanging position from 4 pieces of truss.And 1 lighting instrument. I choose to use geometry for the hanging position.
Creating the schematic view takes multiple minutes of beachball to complete.
Once the schematic view is there only 1 out of 4 pieces of truss is displayed in the schematic view. (the one that has the instrument attached.)
Moving a schematic view takes another couple of minutes of beachball.
I can not rake a hanging position that has no instruments attached unless I check draw 3d only. But checking draw 3D only makes the schematic view not visible.
Deleting a schematic view takes another couple of minutes of beachball.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Sebastiaan
I just did a quick little test for schematic views.
I created a hanging position from 4 pieces of truss.And 1 lighting instrument. I choose to use geometry for the hanging position.
Creating the schematic view takes multiple minutes of beachball to complete.
Once the schematic view is there only 1 out of 4 pieces of truss is displayed in the schematic view. (the one that has the instrument attached.)
Moving a schematic view takes another couple of minutes of beachball.
I can not rake a hanging position that has no instruments attached unless I check draw 3d only. But checking draw 3D only makes the schematic view not visible.
Deleting a schematic view takes another couple of minutes of beachball.
Can this be looked at?
Link to comment
7 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.