Jump to content

Slab drainage to slab component?


Kazemester

Recommended Posts

Hi,

I was searching the forums for this, but i couldn't find anything relevant...Is there any options to set the drainage slope to a specific slab component when i place a slab drainage or can i set that after? Is this even in VW yet or the drainage tool always sets the slope for the top component? ( I want it to be set on 2-3 layers below and set the above components parallel to the sloped one.)

Sorry for the question if its a simple thing, i just can't find a solution for it.

Thank you!

Link to comment
  • 2 years later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...