Kazemester Posted September 7, 2019 Share Posted September 7, 2019 Hi, I was searching the forums for this, but i couldn't find anything relevant...Is there any options to set the drainage slope to a specific slab component when i place a slab drainage or can i set that after? Is this even in VW yet or the drainage tool always sets the slope for the top component? ( I want it to be set on 2-3 layers below and set the above components parallel to the sloped one.) Sorry for the question if its a simple thing, i just can't find a solution for it. Thank you! Quote Link to comment
Kazemester Posted September 7, 2019 Author Share Posted September 7, 2019 Never mind...found the "tapered" setting in the slab component settings... Murphy... 1 Quote Link to comment
Héctor Rangel Posted May 3, 2022 Share Posted May 3, 2022 thanks for your autoresponder, 3 years later it helped me to solve a slab that moved too much 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.