Jump to content
ghunter

Reset Braceworks IDs not working in SP4?

Recommended Posts

I recently upgraded to SP4 and when I use the Reset Braceworks IDs command in any existing plans, VW crashes.  The progress dialog displays but about half way in there is a crash.  I created some simple new test plans, they seem to reset properly but then they don't contain anywhere near the number of hoists/truss etc as the existing plans.  Is anyone experiencing this issue?

 

Thanks

Share this post


Link to post

I have had the same when resetting the IDs with nothing selected, It seems to try to set an ID for every object in the drawing

Share this post


Link to post

I had the same in one drawing a while back. It turned out to be an issue with a lighting unit's Braceworks ID. When you reset, it resets everything. I sent the file to tech support and they are the ones who found the issue.

Share this post


Link to post

Thanks Scott.  OzCAD here in Australia confirms it crashes in SP4 and beta SP5 so a report has been raised.  I am going to revert to SP3.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...