I've created a pillar (post) and would like to join it to the roof face. I've extruded a surface from the underside of the roof and have selected both the surface and the pillar and then used the section solids tool to 'break' the pillar at the newly created roof surface however I continue to get an error message saying the geometry i've chosen is incorrect....or something along those lines. Help?
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
skeyshubber
Hi,
I've created a pillar (post) and would like to join it to the roof face. I've extruded a surface from the underside of the roof and have selected both the surface and the pillar and then used the section solids tool to 'break' the pillar at the newly created roof surface however I continue to get an error message saying the geometry i've chosen is incorrect....or something along those lines. Help?
Link to comment
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.