fuberator Posted July 10, 2019 Share Posted July 10, 2019 Hi I have some ETC source four lustr with a 15-30° zoom. I would like to see them at 30° in vision, but I can't seem to figure out which parameter in VW controls this Thanks for advice Quote Link to comment
Vectorworks, Inc Employee bbudzon Posted July 10, 2019 Vectorworks, Inc Employee Share Posted July 10, 2019 I'm not sure that it is possible to send the Zoom value from VW to Vision. However, to control the Zoom of this fixture in Vision simply select the fixture in the Scene Graph Dock and then open Vision's Software Console. Inside of the console, you should see a slider for Zoom. I believe a value of 255 is 30deg 😉 Quote Link to comment
fuberator Posted July 12, 2019 Author Share Posted July 12, 2019 got it, thank you! 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.