when I try to introduce a vertical excavation into my site model, I get very rough edges as seen on the attached screenshot. the site model is based on a 10x10cm resolution laser scan. the rough edges are probably the effect of the triangulation vectorworks uses.
is there any way to get smoother geometry when editing site models?
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
PO4
when I try to introduce a vertical excavation into my site model, I get very rough edges as seen on the attached screenshot. the site model is based on a 10x10cm resolution laser scan. the rough edges are probably the effect of the triangulation vectorworks uses.
is there any way to get smoother geometry when editing site models?
thank you
yves
Link to comment
5 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.