i was hoping someone could help me in regards to a problem with drawing a simple circle or arc and the edge of the arc is seriously jagged. I don't think i have ever had this problem but has come to my attention in the last couple of days.
When i'm in Top/plan view its fine but moving into 3d Top view or any other view the radius will go jagged, is this just normal in vectorworks? i think all my settings are correct
Open GL - detail set to Very high
Use Anti - Aliasing checked
Navigation graphics - Good performance and compatibility
2d conversion resolution - Very high
3d conversion resolution - Very high
I've also made sure my graphics card is up to date and i have Service pack 3 but it just seems weird that a simple circle in a blank document is so jagged? ive attached a screen shot of the circle and if anyone could shine some light that would be much appreciated. Thanks Louis
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Louis Wilson
Hi All,
i was hoping someone could help me in regards to a problem with drawing a simple circle or arc and the edge of the arc is seriously jagged. I don't think i have ever had this problem but has come to my attention in the last couple of days.
When i'm in Top/plan view its fine but moving into 3d Top view or any other view the radius will go jagged, is this just normal in vectorworks? i think all my settings are correct
Link to comment
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.