Jump to content
  • 0

Nurbs Roadway


Ian M.

Question

7 answers to this question

Recommended Posts

  • 0

I have had that happen before. Frightening😫. There are three (I think) toggle modes in the reshape. You need to make sure that the movement is constrained to the x and y axes. Better yet, and because of this, I stopped trying to make those sorts of adjustments by mouse action and instead type in the numbers I need. I even usually resort to going back a couple steps, to the original polyline (saved off to the side). Duplicate, make needed corrections in 2d, then re-create road. Then I go vertex  by vertex as needed to adjust grades. It's trial and error (at least for me) and sometimes takes three times to get it how I want it, but it's SO much better than old school by hand method. And once it's right, bob's your uncle.

Link to comment
  • 0

@CipesDesign since I have your attention...is there a way to select a station point then specify the desired grade for a specified number of station points?  I could measure the distance and calculate an elevation, then "Align stations vertically", but I was wondering if I could get Vectorworks to let me type in "8.33%"?

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...