Carl Burnett Posted April 23, 2019 Share Posted April 23, 2019 Hello, Why is this happening? how can I rectify it? So I have GLP X4's I position them correctly in VW when I export to Vision they seem to position themselves randomly as you can see by the attached photos. I tried turning them by 90 degrees in VW you can again see how Vision positions them. VW and Vision are both 2019 SP3 Any ideas please? Thank you Quote Link to comment
Vectorworks, Inc Employee klinzey Posted April 24, 2019 Vectorworks, Inc Employee Share Posted April 24, 2019 Which GLP X4? It looks like the GLP Impression X4 Bar but which one and which which fixture mode did you select? Quote Link to comment
Gaspar Potocnik Posted April 25, 2019 Share Posted April 25, 2019 I've had the same issue with some LED bars swell, I believe it was with TecShow StickTriTec and Blaster Pixelbar 12. Quote Link to comment
Carl Burnett Posted May 2, 2019 Author Share Posted May 2, 2019 Hi Klinzey, It is the GLP X4 Bar 20, 20 Channel Quote Link to comment
Carl Burnett Posted May 17, 2019 Author Share Posted May 17, 2019 Hi everyone, Wondered if anyone had a solution to this orientation issue. I really need to start programming and this is obviously an issue! Thanks for your help. Carl Quote Link to comment
Gaspar Potocnik Posted May 17, 2019 Share Posted May 17, 2019 2 hours ago, Carl Burnett said: Wondered if anyone had a solution to this orientation issue. I really need to start programming and this is obviously an issue! In Vision change the rotation of anything you need, as simple as that. Once it is saved it will show up the proper way each time you load the /v3s file. Quote Link to comment
Carl Burnett Posted May 17, 2019 Author Share Posted May 17, 2019 Really? i have tried rotating by 90 degrees, is that what you mean? Quote Link to comment
Gaspar Potocnik Posted May 17, 2019 Share Posted May 17, 2019 Yes. Select your fixtures, in the properties windows expand the Rotation tab and enter a value in the coordinate you want. It looks like some must have a different Y value, you can select all and change the value for all of them and then adjust... Quote Link to comment
Carl Burnett Posted May 17, 2019 Author Share Posted May 17, 2019 Thanks, i’ll give it a go tomorrow and let you know. appreciate your help. Carl Quote Link to comment
Carl Burnett Posted May 21, 2019 Author Share Posted May 21, 2019 Hey Gaspar, that worked, so it's a good work round, but if I make any mods to the VW file I'm back to square one. Thanks for the solution carl Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.