I have been trying to configure rather simple stair. In 2018 it nearly impossible, but in 2019 I am getting close. My main issue is that I am getting error messages (two treads are partially melted..., etc) that doesn't explain what is wrong and it does not make sense geometrically. So I am wondering if anybody knows which settings are causing this. Also, I arrived at this configuration by trial and error changing different values till I almost got what I wanted. Also, it is not possible to have nosing in this stair, I unlocked overall stair dim . Attached is line drawing of the stair and above is VW stair which has one offset set at 2" and it cannot get smaller.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
TKA
I have been trying to configure rather simple stair. In 2018 it nearly impossible, but in 2019 I am getting close. My main issue is that I am getting error messages (two treads are partially melted..., etc) that doesn't explain what is wrong and it does not make sense geometrically. So I am wondering if anybody knows which settings are causing this. Also, I arrived at this configuration by trial and error changing different values till I almost got what I wanted. Also, it is not possible to have nosing in this stair, I unlocked overall stair dim . Attached is line drawing of the stair and above is VW stair which has one offset set at 2" and it cannot get smaller.
Link to comment
3 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.