Jump to content

Question

I have been trying to configure rather simple stair.  In 2018 it nearly impossible, but in 2019 I am getting close.  My main issue is that I am getting error messages (two treads are partially melted..., etc) that doesn't explain what is wrong and it does not make sense geometrically.  So I am wondering if anybody knows which settings are causing this. Also, I arrived at this configuration by trial and error changing different values till I almost got what I wanted.  Also, it is not possible to have nosing in this stair, I unlocked overall stair dim .  Attached is line drawing of the stair and above is VW stair which has one offset set at 2" and it cannot get smaller.

Screen Shot 2019-03-14 at 5.01.10 PM.png

Share this post


Link to post

2 answers to this question

Recommended Posts

  • 0

All the stair tools to date remind me of the line from Dante's Inferno often shortened to L.O.S. :

 "Lasciate ogne speranza, voi ch'intrate"

Share this post


Link to post
  • 0

so I managed to get it done with legacy custom stair tool.  I think there should be a check box "override stair tool logic"

 

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×