Jump to content
  • 0
chris cox

Gobos getting cut off

Question

I created a custom gobo (well two of them) and when I import the artowork into the resource libraryit is placing the artwork in lower left corner of the area and causing the edge to be cut off. See snap shot from screen 

Capture3.PNG

Capture2.PNG

Capture.PNG

Share this post


Link to post

2 answers to this question

Recommended Posts

  • 0

I thought the gobo shift feature would help but it didn't HELP!!! lol

 

Share this post


Link to post
  • 0

The problem is likely your source image. Just like a real gobo, your source image needs to fit within the circle generated by the light.

It's a little hard to tell because your image is also a rectangle but if you look you will see that your missing areas are clipped by the circular light.

The overall image must be square.

We recommend a 2"x2" square with black filled to the edge and then a slightly smaller circular area for the image area.

Image Area.jpg

A lot of gobo shift would work but you will then start to see light bleed around the gobo image.

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×