Door doesn't show that it is attached to the wall

[ahenrie2450]

So the wall has the wall insert mode on. It is also on the same layer as the door.  The door is using the wall depth.  The door also has a height to it. When I go to insert the door I do see the red lines around the wall. Then the door is in place but I still see the wall instead of the opening of the door. In this jpeg example door D-01B. What am I missing?

[PVA - Admin]

With that door selected, does it say it is a Door or Door in Wall? If you delete that door and insert a different one of a different style from the door tool, does that one break it? If you take that same door and insert it into a new wall in a new blank file, does it break the wall like it should? The red highlighting you mentioned normally indicates the other stuff is all correct, selectable layers and the insertion mode, etc.

 

[ahenrie2450]

It does say door in wall. Door does break wall other places.

 

[PVA - Admin]

There are not two walls overlaid in the same location there?

[ahenrie2450]

Nope

[PVA - Admin]

Send me that VWX file please, in a private message is fine if it shouldn't be posted publicly.

[ahenrie2450]

Just going to start fresh with a new door