Josh Schulman Posted February 26, 2019 Share Posted February 26, 2019 I'm trying to make some custom truss that technically is a 4-way corner block. There are connection points at each end of the truss and two offset toward one side. Here are some screen grabs of what I'm working on. When I try to make the connection on the offset side, I'm getting some really results. Thoughts? Offset Truss.vwx Quote Link to comment
Josh Schulman Posted February 26, 2019 Author Share Posted February 26, 2019 my insertion point is currently at the end of the truss near the T. Quote Link to comment
Josh Schulman Posted February 26, 2019 Author Share Posted February 26, 2019 Here you go and thanks! Offset Truss.vwx Quote Link to comment
Josh Schulman Posted February 26, 2019 Author Share Posted February 26, 2019 Aha! Good to know. Thanks again! Quote Link to comment
Josh Schulman Posted March 5, 2019 Author Share Posted March 5, 2019 Hey @Rob Books crazy question for you. What if I had a truss that had multiple connection points along it at different heights? Can braceworks do that? Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.