I am experiencing difficulties with push/pool tool. My latest project (but also in all other files) with very simple geometry of one and half storey small house. Whenever I want to use this tool it behaves unpredictable for few seconds it works then for few second spinning ball occur and all over again. Tool seem to be confused ... of basic geometry?
File newly created in VW 2019.
At the moment It is impossible and useless to use this tool in front of client to show some quick and even very very simple modifications of 3D objects.
Beside that there are plenty other places when vw get stuck either for few seconds - in better case or good few minutes...especially in area of 3D - AEC when selecting some objects. Hope this too will be fixed very soon.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
drelARCH
Hi Vectorworks
I am experiencing difficulties with push/pool tool. My latest project (but also in all other files) with very simple geometry of one and half storey small house. Whenever I want to use this tool it behaves unpredictable for few seconds it works then for few second spinning ball occur and all over again. Tool seem to be confused ... of basic geometry?
File newly created in VW 2019.
At the moment It is impossible and useless to use this tool in front of client to show some quick and even very very simple modifications of 3D objects.
Beside that there are plenty other places when vw get stuck either for few seconds - in better case or good few minutes...especially in area of 3D - AEC when selecting some objects. Hope this too will be fixed very soon.
Thanks in advance for reply.
Pavol
Link to comment
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.