Jump to content

LIghting Fixture Align


Recommended Posts

Two methods.

1. Once the light attaches itself to the center of the truss, you can move them US/DS and it stays connected with a little leader line.

2. Convert the truss to a hanging position using the truss geometry first, then hang the lights. Usually works in that the light gets sucked into the position even though it's not centered.

In may attached sample, the LampBar has all the light aligned to the bar, but you can see that the lights have a leader line back to the center of the truss. Thus, the lights have the little triangle for the option to move to hanging point, or remove from hanging point.

I then tested my #2 from above by copying unit #10 and placing it on the rear cord. Yup, it thinks it's attached the truss and the truss (Hanging Position Object) thinks the light is attached. Didn't need to attach to the center red line.

 

hth, Scott

2019-01-10_16-12-44.png

Edited by SCParker
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...